78-9000-5020-0 Rev C 19
D. Enabling/Disabling Locating Frequencies
Menu/OK [6:Toggle to MAIN MENU] + >>More [SK:4] + [SK:5] + >>More [SK:d] +
LocateFreq[SK:f]
The user can select the frequencies that the receiver will detect. All the available
frequencies are listed in four groups (Left to Right: Active, Power, Passive, and
Auxiliary). The Auxiliary group also contains the User Dened Frequencies. (See 5G.
Creating User Dened Frequencies.) The box below the Auxiliary group allows the
selection of ltering for 50 Hz or 60 Hz passive signals when User Dened frequencies
have been chosen for locating.
• Press the right arrow [SK] to move the highlight
bar to the section of frequencies to enable, or
disable.
• Press the up/down arrows [SK] to highlight the
specic frequency.
• Press Enabl/Disabl [SK]. (Enable denoted by )
• Repeat steps 2 & 3 to enable/disable other
frequencies.
• Press Menu/OK [6] to save.
E. Selecting Locate Modes (Antenna Modes)
Menu/OK [5: Toggle to MAIN MENU] + >>More [SK:4] + [SK:5] + >>More [SK:d] + Locate
Modes [SK:e]
The user can select the locate modes (antenna modes) that the receiver utilizes. There
are ve locate modes that are available; Trace View (T-View), Directional Peak (Dir Pk),
Directional Null (DirNull), Special Peak (Spl Pk) and Induction Peak (Ind Pk).
All ve modes are activated when shipped. The user can deactivate any of the modes that
will not be used.
• Press the up/down arrows [SK] to highlight a
specic locate mode in the rst column.
• Press the right arrow [SK] to move the highlight
bar to the second column, or back to the rst
column.
• Press Enabl/Disabl [SK]. (Enable denoted by )
• Repeat steps 2 & 3 to enable/disable other locate
modes.
• Press Menu/OK [6] to save.
To Next Page
Loading...
Need help?
General
