A&D TM-2441 - Page 50

32
Home blood pressure HBP
When the / switch is pressed, HBP is started.
The HBP performs a "1 scope".
"1 scope" consists of a set of blood pressure measurements and
interval times which are repeated to the number of the
measurement count. The last interval time is omitted.
When the
/ switch is pressed during the "1 scope", the "1
scope" is stopped.
T : Interval time
Press the / switch to start the "1 scope".
T
Time
T
T T
Press the
/ switch to start the "1 scope".
Press the / switch to stop the "1 scope".
T
Time
T T T
Blood pressure measurement
1 scope
Not measured