A&D TM-2441 - Page 52

34
Automated self blood pressure ASBP
The ASBP can specify up to six preset start time for the alarm.
When parameters for the ASBP program are stored, the ASBP is
started and the buzzer sounds at each Start time. Press the
/ switch to perform a "1 scope" when the buzzer sounds.
"1 scope" consists of a set of blood pressure measurements and
interval times which are repeated to the number of the measurement
count. The last interval time is omitted.
Note
Manual blood pressure measurement of the ASBP
When the / switch is pressed in waiting mode between last "1
scope" and next "1 scope", The "1 scope" is performed.
T : Interval time
The ASBP is started at the same time when ASBP program is set.
(The ASBP becomes waiting mode until start time)
Press the /
switch to start "1 scope".
Start time of alarm
Press the /
switch to start "1 scope".
Start time of alarm
1 scope
T
Time
T T
T
Blood pressure measurement
T
Time
T T
T
T
T
Press the
/ switch
to perform the manual-BPM.
1 scope
1 scope
1 scope 1 scope