Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-35
5.4.4.10 Login/logout Function – in release 3.2 and later
In release 3.2 and later, the login/logout function enables you to assign another number to a set
that is already logged on.
This function is implemented by using feature access codes *44 to retrieve subscriber rights from
another set, and #44 to deactivate them.
• To assign another number (and retrieve subscriber rights), enter successively:
- the feature access code
* 4 4
- the extension number
- the set's secret code.
• To deactivate the number assignment function, enter the feature access code
# 4 4
5.4.4.11 Summary of installer codes used
The following table gives the various parameters that can be accessed:
Access condition: Code: Function:
After power up, at the end of the
initialisation period, when "?" is
displayed and within 5s
Prog * 1 Configuring network parameters
In standby and during a call Prog * 2 Viewing the configured parameters
Accessible any time Prog * 5 Viewing the identification parameters
After power up, at the end of the
initialisation period, when "?" is
displayed and within 5s
Prog * 7 Configuring Ethernet parameters
In standby Prog * * Restarting the set
After power up, followed with
to validate
Prog * 9 Return to the factory parameters and to the
default IP configuration (total DHCP,
disappearance of subscriber’s number).
To Next Page
Loading...
