Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-27
5.4.4 Installation
5.4.4.1 Connections
Refer to the network connection diagram in section 12.1.2.
If required, refer to the mains connection diagram, section 12.2.4.3.
5.4.4.2 Connections
To the LAN: using an Ethernet cable (remote supply possible via the LAN).
Set of 10 Ethernet cables sold in the catalogue under reference HT1455A.
Nota : If the cord is sleeved, a DH520A adapter must be used.
To the telephone handset: by a coiled cable with an RJ9 type male connector at each end.
To the headset: see Section 12.3.1.
To the mains: by power supply unit (Ref. : PN1121D) if power is not remotely supplied to the set
via the LAN.
5.4.4.3 Default settings on delivery
Current ring tone: : 4
Current ring volume : 4
Private directory ring tone Private : 8
Private directory ring volume : 4
Contrast : 4
Key sound : 4
Headset microphone : 5
Group listening : 6
Handset listening : 5
To Next Page
Loading...
