AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP sets
Page 5-46 05/2008 To install sets and cartridges in the i7XX range
5.5.4.9 Summary of installer codes used
Access condition: Code: Function:
After power up, at the end of the
initialisation period, when "?" is displayed
and within 5s
* 1 Configuring network parameters
In standby and during a call * 2 Viewing the configured parameters
After power up, at the end of the
initialisation period, when "?" is displayed
and within 5s (before set version R5.3)
Accessible at any moment as from set
version R5.3
* 5 Viewing the identification parameters
After power up, at the end of the
initialisation period, when "?" is displayed
and within 5s
* 7 Configuring Ethernet parameters
In standby (as from set version R5.3) * * Restarting the set
To Next Page
Loading...
