Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
SIP PHONEs 480i, 9112i and 9133i 05/2008 Page 8-49
8.9.9.3 Configuring the Ethernet switch
In accordance with the general recommendations for the NeXspan solution, a sub-division into
VLAN must be used:
• A VLAN comprising PT2/PVI/IPS cards and NCS
• One or more VLAN containing SIP phones
• One VLAN containing telephony servers (messaging system, administration, etc.)
• One or more Data VLAN
Standalone phones:
Phones with a PC:
Phone configuration
(WEB interface/ aastra.cfg format)
Ethernet switch configuration
VLAN Enabled (no) / tagging enabled=0 Port in ‘access’ mode (CAD: no 802.1Q
marking). The port is in a ‘Phones’ VLAN.
VLAN Enabled (yes) / tagging enabled=1
Port 0 VLAN ID 20 / VLAN id: 20
Port in ‘trunk’ mode in VLAN 20. The phone
and Ethernet switch mark the frames in
802.1Q.
Phone configuration
(WEB interface/ aastra.cfg format)
Ethernet switch configuration
VLAN Enabled (yes) / tagging enabled=1
Port 0 VLAN ID 20 / VLAN id: 20
Port 1 VLAN ID 30 / VLAN id port 1: 30
Port in ‘trunk’ mode in VLAN 20 and 30. The
phone and Ethernet switch mark the frames in
802.1Q. The frames to the PC are marked; it is
the SIP phone that manages the marking to the
PC.
To Next Page
Loading...
