Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
Installation of sets in the M7xx range 05/2008 Page 4-15
Procedure (Before R1.3)
Once the set is connected, the screen of the M740 is displayed:
Nota : "SET LANGUAGE
Æ
OK" remains displayed, forcing the user to select (if required) then
validate the language.
By default, the set is delivered in English, the first option proposed being "FRANCAIS".
Attention :
Only by pressing the red key it is possible to exit this mode without selecting a
language, the standby screen displayed (date and time) being set to the PBX's
language. In this case only
(after disconnecting the set), when the set is started
again, this language selection sequence will be proposed again. This enables
the installer to check the set's operation while maintaining the initial
configuration.
•Press
Select the language using the navigator's up or down arrows (if required)
Example: Press
•Press
2 confirmation beeps, then back to the idle screen
Note: In case of error or change, to change the language,
•Press
• Select the "LANGUAGE" menu using ,
• Press then select a language.
M740 Ry.yxx--
SET LANGUAGE
Æ
To Next Page
Loading...
