Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-23
5.3.4.9 To log out – prior to r3.2
The purpose of the Log out procedure is to allocate another number to a logged set.
To log out a set, the following operations must be carried out:
• Unplug and plug the set back in. An initialisation phase is activated (at the end of this
initialisation phase, a question mark is displayed to the left of the display)
• Enter the following sequence within 5 seconds:
* 1("Prog"*1) to enter network parameters in the configuration menu, the menu option
"Phone number" is displayed.
"Description" zone:
Then, the standby screen is displayed with a prompt to enter a directory n° like the first time the set
was started.
WRGHOHWHE\SUHVVLQJ
VXFFHVVLYHO\
'LVSOD\RIWKH
'LUHFWRU\
QXPEHURSWLRQ
WRGHOHWHE\SUHVVLQJ
VXFFHVVLYHO\
$IWHUGHOHWLRQ
To Next Page
Loading...
