Hardware Installation
1. Level the cabinet by adjusting the feet (A) using the 24-mm U-ring wrench,
Page 28
2. Verify that the cabinet is leveled horizontally and vertically, using a water
level.
3. Tighten the locking nuts (B) on all feet using the 24-mm U-ring wrench,
Page 28
4. Proceed to the next installation stage:
• For installation of a cabinet with tip protection, Section 4.2.6 on page
29 .
• For installation of a cabinet with earthquake bracing frames, Section
4.2.7 on page 33 .
4.2.6 Installing the Cabinet with Tip Protection
Table 7 Mounting Set for Tip Protection
18/BYB 501/4 Tip protection, generic
Pos. Title/Function Product Number Quantity
A YOKE SXA 123 0786/1
2
B SPACER SXA 123 0788/1
6
C EXPANDER SCREW M 8X90 NSV 905 0805
4
D INSULATING WASHER SRB 186 080
4
E SUPPORT SXA 123 0785/1
4
F CLAMP2 SXA 123 0787/1
4
G NUT M 8 SBM 146 080/03
4
H INSULATING PLATE SXA 123 0789/1
4
STUD SCREW M 8X650 SBK 255 70
4
EXPANDER NUT M 8x30 SXA 113 2519
4
L WASHER SCA 101 080/03
8
BUSHING SRG 107 16/1
4
WASHER SCA 350 06
4
296/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...