Installing MX-ONE
Figure 16 Installing the Tip Protection
Note: The following procedure must be performed for the feet at the front
and for the feet at the back:
1. Insert three spacers (B) in the holes in the yoke (A), Page 30
2. Slide the yoke under the cabinet between the feet.
3. Move the yoke back over the feet.
4. Align the holes in the yoke with the two anchoring holes (X) in the floor.
5. Anchor the cabinet to the floor according to the type of floor. For a concrete
floor, Section 4.2.6.1 on page 31 . For a raised floor, Section 4.2.6.2 on
page 32 .
30
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...