Hardware Installation
4.2.6.1 Installing the Tip Protection on a Concrete Floor
Figure 17 Installing the Expander Screw
Note: The following procedure must be performed for the feet at the front
and for the feet at the back:
• Insert two expander screws (C) through the yoke (A) and into the concrete,
Page 31
• Hammer the two expander screws into position. Be careful to the threads.
• Install two insulating washers (D), two washers (L), and two nuts (G) on
the two expander screws, Page 31
• Tighten the two expander screws.
• Proceed to the next installation stage, Section 4.2.8 on page 35 .
31
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...