Installing MX-ONE
4.2.6.2 Installing the Tip Protection on a Raised Floor
Figure 18 Installing the Tip Protection on a Raised Floor
Note: The following procedure must be performed for the feet at the front
and for the feet at the back:
1. Insert two clamps (F) through the yoke (A) and the floor (X), Figure 18
on page 32
2. Secure two supports (E) with two insulated plates (H) to the secondary
section of the raised floor by using the two clamps (F) and two nuts (G),
Figure 18 on page 32
3. Tighten the two nuts (G) from the underside.
4. Proceed to the next installation stage, Section 4.2.8 on page 35.
32
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...