Abarth 595 - Lifting the Vehicle

SERVICING AND MAINTENANCE
138
135AB0A0113C
NOZZLES
Windscreenwasher
If there is no jet, first check that there is
fluid in the reservoir(see the "Checking
fluid levels" paragraph in this chapter).
Then check that the nozzle holes are
not clogged; use aneedle to unblock
them if necessary.
The screen washer jets can be oriented
by adjusting the nozzle angles.
The jets should bedirected at about
1/3 of the height from the top edge of
the windscreen fig.136.
WARNING In versions with a sunroof,
make sure that the sunroof is closed
before operating the front jets.
136AB0A0114C
Rearwindowwasher
The rear window washer jets are fixed.
The nozzle holderis located above the
rear window fig. 137.
137AB0A0115C
WARNING
160) Driving with worn windscreen/rear
window wiper bladesis a serious risk,
because visibility is reduced in bad
weather.
LIFTINGTHE
VEHICLE
39)
As a result of its sporty nature, the car
is fitted with aerodynamic spoilers at
the bottom and side skirts at the sides.
If the car needs tobe raised, go to an
Abarth Dealershipwhich is equipped
with arm lifts and workshop lifts.
IMPORTANT
39) When positioning theworkshop lift
arms, be very careful to avoid damaging
the aerodynamic spoilers and the side
skirts.