GETTING TO KNOW YOUR CAR
18
11)
After releasing the adjustment lever,
always checkthat the seat is locked on the
guides by trying to move it backand forth.
If the seat is not locked into place, it may
unexpectedly slide and cause thedriver to
lose control of the car.
12)
Make sure the backrests are properly
secured at both sides to prevent them
from moving forward,in theevent of sharp
braking, with possibleimpact with of the
passengers.
IMPORTANT
2)
The fabric upholsteryof the seats has
been designed to withstand long-term
wear deriving from normal use of the car.
Some precautions are however required.
Avoid prolonged and/or excessiverubbing
against clothing accessories such as
metal buckles and Velcro strips which, by
applying a high pressure on the fabric in a
small area, could cause it to break, thereby
damaging the upholstery.
3)
Before tilting the backrest, remove any
objects on the seatcushion.
HEADRESTRAINTS
REAR
(where provided)
To extract the rear head restraints
press buttons (2) and (3) fig. 18 at the
side of the two supports simultaneously
and lift them out upwards.
The rear head restraints must be
lifted out with the backrest released
and tilted toward the passenger
compartment or with the tailgate open.
To bring the headrestraint to the
correct position, lift ituntil you hear it
click.
18AB0A0017C
To lower the headrestraint, press
button (2) fig. 18.
WARNING If the rear seats are used,
always set the head restraints in the
"completely raised"position.
STEERINGWHEEL
The steering wheel can be adjusted
vertically.
To adjust bring thelever fig. 19
downward in position (B), then adjust
the steering wheel to the most suitable
position and lock itin this position
bringing the lever inposition (A).
13)14)
19AB0A0018C
WARNING
13)
All adjustments must be carried out
only with the car stationary and engine off.
14)
It is absolutely forbidden to carry
out any after-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft device) that could badlyaffect
performance and safety, invalidate
the warranty and also result in non-
compliance of the car with type-approval
requirements.
To Next Page
Loading...
