145
51)
Rinse immediately to remove soap
to prevent stains. Repeat the operation if
needed.
52)
Follow the instructions on the
waterproofing product container for
perfect results.
53)
The rubber seals onthe soft top
must be cleaned exclusively with water.
If you notice that thistrimis dryor is
sticking, apply talcum powder or products
specifically for rubber trim (silicone spray).
IMPORTANT
6)
Detergents pollute the water. Only wash
your vehicle in areasequipped to collect
and treat waste water from this type of
activity.
INTERIOR
Regularly check that water is not
trapped under themats (due to water
dripping off shoes,umbrellas, etc.), as
this could cause oxidation of the sheet
metal.
166)167)
FABRICSEATSAND
PARTS
Remove dust witha soft brush or a
vacuum cleaner. Itis advisable to usea
moist brush on velvet upholstery.
Rub the seats witha sponge
moistened with a solution of water and
neutral detergent.
PLASTICANDCOATED
PARTS
It is advisable to clean interior plastic
parts with a moistcloth and a solution
of water and non-abrasive mild soap.
Use specific products for cleaning
plastic, without solvents and specifically
designed to prevent damage to the
appearance and colour of the treated
parts, to remove grease and tough
stains.
WARNING Neveruse alcohol, petrols
and derivatives toclean the instrument
panel lens.
LEATHERPARTS
(where provided)
Use only water and neutral soap to
clean these parts.Never use alcohol or
alcohol-based products.
Before using a specific product for
cleaning interiors, make sure that
it does not containalcohol and/or
alcohol-based substances.
ALCANTARAPARTS
(STEERINGWHEEL)
Procedure for restoring Alcantara
applied to the steering wheel:
Treat the surface using a microfibre
cloth moistened with neutral soap and
water, taking careto cover the whole
covered area, applying a uniform light
pressure (do not rub hard).
Rinse and wring out the microfibre
cloth, and pass over the covered area
treated in the previous point again.
Leave it to dry andbrush it gently
with a soft brush.
54)
WARNING
166)
ever use flammable products, such
as petrol ether or rectified petrol to clean
the inside of the car. The electrostatic
charges which are generated by rubbing
during the cleaning operation may cause a
fire.
167)
Do not keep aerosol cans in the car:
they might explode. Aerosol cansmust not
be exposed to a temperature exceeding
50°C. When the vehicle is exposed to
sunlight, the internaltemperature can
greatly exceed this value.
IMPORTANT
54)
Do not use "hard" synthetic brushes
as they could damage the fabric
beyond repair. Cleanthesteering-wheel
completely to prevent differences in
appearance between treated and
untreated zones. Do not use alcohol or
ketone-based solvents.