SAFETY
70
space-saver wheel,beingsmaller than the
original wheel, provides less grip.
67)
The ASRcannot overrule the natural
laws of physics, andcannot increase the
grip available according to the condition of
the road.
68)
The ASRsystem cannot prevent
accidents, including those due to
excessive speed on corners, driving on
low-grip surfaces or aquaplaning.
69)
The capability of theASRmust never
be tested irresponsibly and dangerously,
in such a way as tocompromise personal
safety and the safetyof others.
70)
Do not take unnecessary risks, even if
your vehicle is fitted with an ASR system.
Your driving style must always be suited
to the road conditions, visibility and traffic.
The driver is alwaysresponsible for road
safety.
71)
The PBA system cannot increase tyre
grip on the road over the limits imposed
by laws of physics:always drive carefully
according to the conditions of the road
surface.
72)
The PBA system cannot prevent
accidents, including those due to
excessive speed on bends, travelling on
low-grip surfaces or aquaplaning.
73)
The PBA system isan aidfor the
driver, who must always pay full attention
while driving. The responsibility always
rests with the driver.
74)
The capability of thePBA system
must never be tested irresponsibly
and dangerously, insucha way as to
compromise the safety of the driver, the
other occupants ofthe car or any other
road user.
iTPMS(indirect
TyrePressure
MonitoringSystem)
(where provided)
DESCRIPTION
The car can be equipped with the
iTPMS (indirect TyrePressure
Monitoring System) which monitors the
tyre inflation statusthanks to wheel
speed sensors.
To access the iTPMS screens ( fig. 66 -
fig. 67), press the TRIP button.
The fig. 67 screenwill be displayed only
if one or more tyres are flat.
Correcttyrepressure
If the pressure of all the tyres
corresponds to the correct value, the
display shows thefig. 66 screen.
Lowtyrepressure
The system warns the driver if one or
more tyres are flatby switching on the
warning light on theinstrument
panel.
66AB0A0123C
The display will show “KO” beside
the tyres fig. 67 along with a warning
message.
67AB0A0217C
If the system doesnot recognise the
pressure value ofone or more tyres,
the display will show dashes "– –"
This indication is displayed also when
turning the engineoff and on again until
the RESET procedure is carried out.