GETTING TO KNOW YOUR CAR
40
ROOFRACK/SKI
RACK
FASTENERS
The fasteners arelocated in the area
indicated in fig. 57. To use the front
fasteners, removethe cap (1) fig. 57,
accessible with thedoor open.
57AB0A0324C
The rear fixing areas (2) can be found
according to measurements shown in
fig. 58.
38)39)40)
16)
Lineaccessori Abarth provides a
specific roof rack/ski rack for the
tailgate.
58AB0A0055C
WARNING Follow the instructions
contained in the assembly kit carefully.
Assembly must beperformed by
qualified personnel.
WARNING
38)
Fully comply with theregulations
in force concerning maximum
clearance. Never exceed the maximum
permitted loads; seechapter "Technical
specifications".
39)
Evenly distribute the load and take
into account, whendriving, the increased
responsiveness of the car to side wind.
After travelling for a fewkilometres, check
to ensure that the fixing screws for the
attachments are well tightened.
40)
Before driving, make sure that the
transversal bars have been fitted properly.
IMPORTANT
16)
The use of transversal bars on
longitudinal ones prevents the use of the
sunroof, because the latter, while opening,
interferes with the bars. Therefore do not
move the sunroof iftransversal bars have
been fitted.
FIREEXTINGUISHER
(where provided)
There may be a fireextinguisher (1)
fig. 59 in the boot, to be used in the
event of fire.
To use the fire extinguisher, loosen the
retaining strap andremove it from its
case.
59AB0A0362C
To Next Page
Loading...
