Abarth 595 - Page 193

MULTIMEDIA
180
"Download TomTom HOME", then
follow the instructions provided.
Connect the USBdevice prepared
with the computer. TomTom HOME is
started automatically.
Select "Log in" in the top right corner
of TomTom HOME.
Select "Create account" and enter
the required detailsto create a
MyTomTom account. A MyTomTom
account is requiredto receive map
updates. After theaccount is created,
you are asked whether you wish to
connect the
Uconnect™ system
to your account. The USB device
prepared represents your
Uconnect™
system.
Select “Connect device”, then
select “close”. A map can now be
downloaded to theUSB device.
Downloadingamap
The map can be updated in two ways:
Most recent mapsguarantee: if a
new map is available for your system
within 90 days of initial use, it can be
downloaded oncefree of charge.
Map update: it is possible to
purchase a new version of the map
installed on the system.
To check availability or purchase
a map, make surethat you have
prepared a USB device and installed
TomTom HOME on your computer.
Connect the USBdevice to the
computer.
Downloadingamap
If a map update isavailable for the
system, this update is included in the
list of updates available.
NOTE If the mostrecent map is already
installed on the system, the update is
not proposed. Select the map that you
wish to download,then select "Update
and install".
The map is downloaded and copied to
your USB device.
Select "Done" when the process is
complete.
NOTE Don’t disconnect the USB
device from the computer while
map downloadingand copying is in
progress.
The map can nowbe installed on the
system.
Installingthemap
After downloading amap to your USB
device, it can be installed on your
system.
WARNING The map update MUST be
made with the vehicle engine running
and may require more than 30 minutes.
WARNING Do notdisconnect the
USB device duringthe map installation
process, otherwise installation will be
interrupted.
Insert the USB device containing the
new map in the
Uconnect™ system.
The system detects a new map on the
USB device.
Select "Start".
Keep the device inserted. Before
updating the map,the system indicates
that this process may take several
minutes. Select "OK".
NOTE Do not remove the USB device
and do not disconnect the system’s
power supply before the update is
complete. The system cannot be used
until the update iscompleted correctly.
If the update is interrupted, the system
update is started again.
Once the map has been updated, the
following messageis displayed.
Click on “Close”.
The new map is now available on the
system.
Troubleshooting
The following problems may occur
during the update:
The map on the USB device is
not valid. In this case, download the
map to the USB device again, using
TomTom HOME. Itmay be necessary
to prepare the USB device again.