35
once the all closedposition has been
reached, continueto press the button
until the soft top makes a full opening
and closing run.
WINDSTOP
The Wind Stop fig. 43 is designed to
improve driving comfort, by reducing
air turbulence in the passenger
compartment when travelling with the
soft top down.
43AB0A0328C
To use it:
Release the backrest of the rear seat
(single or split).
Attach the Wind Stop by inserting
the central part inside the rear screen
guard, with the concave part in the
direction of the passenger, as shown in
fig. 43;
re-position the backrest correctly; the
Wind Stop is lockedbetween the seat
and parcel shelf.
FRONTSPOILER
The car is providedwith a front spoiler
which can be raised to improve
aerodynamic comfort inside the
passenger compartment.
To lift the spoiler, release the catch
by means of the slider (1) moving it to
position (B) as shown in fig. 44.
With the spoiler raised, take care not to
move the slider (1)from position (B) to
position (A).
To lower the spoiler, press and move
the slider to position fig. 45 to lock it
once the slider’s catch is positioned
inside its housing (A) fig. 44.
44AB0A0329C
45AB0A0330C
It is advisable to raise the spoiler when
the horizontal segment of the top
is open and at speeds faster than
50 km/h.
With the top completely open, it is
advisable to keepthe spoiler lowered
to limit wind noise inside the passenger
compartment.
Raising the spoilerwill reduce the flow
of air to the rear seats.
WARNING
24)
Keep hands away from the top
mechanism while opening and closing the
top or if the top stops in a position before
completing the cycleto prevent damage
and injury.
25)
Keep children awayfrom the area in
which the top is folding during opening or
closing operations.
26)
When leaving the car, always remove
the key from the ignition device to avoid
To Next Page
Loading...
