Abarth 595 - Page 64

51
press the + or – buttons to select
“Yes” (to confirm enable/disable) or
“No” (to abort);
press the MENUbuttonbriefly,
a message confirming the selection
will be displayed and you will return to
the menu screenor hold the button
down to return tothe standard screen
without storing.
Passengerprotectionoff:
instrument panel LED
on fixed.
Daytimerunninglights
(DRL)
(where provided)
With this function ispossible to turn the
daytime running lights on and off.
Proceed as followsto activate or
deactivate this function:
press the MENUbuttonbriefly to
display a submenu;
press theMENU button briefly,
the display will flash"On" or "Off"
depending on theprevious setting;
press + or – buttonto select;
press theMENU button briefly to
return to the submenu screen or hold
the button down to return to the main
menu screen without saving;
hold the MENU buttondown
again to return to the standard screen
or to the main menu according to
where you are in the menu.
Resettyres(iTPMS
reset)
(where provided)
With this function it ispossible to reset
the iTPMS (see paragraph “iTPMS”).
To carry out the Reset procedure
proceed as follows:
briefly press the MENUbutton:
the display will show Reset;
press the + or – button to select
(“Yes” or “No”);
briefly press the MENUbutton:
the display will show “Confirm”;
press the + or – button to select
("Yes" to reset or "No" to exit the video
page);
briefly press the MENUbutton
to confirm the selection ("Yes"/"No"). If
you answer Yes,the reset is confirmed.
hold the MENU buttondown
again to return to the standard screen
or to the main menu according to
where you are in the menu.
Radiorepetition(audio
informationrepetition)
(where provided)
This Menu item allows some
information displayed on
Uconnect™
system to be repeated on the
instrument panel display.
To show the
Uconnect™ information
on the display ("On"), or clear it ("Off"),
proceed as follows:
press theMENU button briefly,
the display will flash"On" or "Off"
depending on theprevious setting;
press + or – buttonto select;
press the MENUbuttonbriefly to
return to the menuscreen or hold the
button down to return to the standard
screen without storing.
Seephone
(where provided)
This Menu item allows some
information displayed on
Uconnect™
system to be repeated on the
instrument panel display.
To show the
Uconnect™ information
on the display ("On"), or clear it ("Off"),
proceed as follows:
press theMENU button briefly,
the display will flash"On" or "Off"
depending on theprevious setting;
press + or – buttonto select;
press the MENUbuttonbriefly to
return to the menuscreen or hold the
button down to return to the standard
screen without storing.
Seenavigation
(where provided)
This Menu item allows some
information displayed on
Uconnect™
system to be repeated on the
instrument panel display.