Operation Manual / 4 Product description / A100-M axial
2 Removal and installation / 2.2 Removing the turbocharger
© Copyright 2019 ABB. All rights reserved. HZTL4033_DE Revision C February 2019
Turbocharger with clamping nuts
Fig.7: Removing the foot mounting
1. Treat the threads of the threaded rods with penetrating oil and allow it to work in.
Do not oil the pressure screws of the clamping nut.
2. Undo the clamping nuts at the compressor-end and turbine-end foot (see Loosening the
clamping nut →11).
3. Fit transport screws (90334 / 90335) to secure the sliding block (68003) on the left and
right on the turbine-end foot.
u Lift the turbocharger from the engine and put it down.
u Cover all oil connections.
Page 10 / 108
To Next Page
Loading...
