Operation Manual / 4 Product description / A100-M axial
3 Commissioning / 3.1 Oil supply
© Copyright 2019 ABB. All rights reserved. HZTL4033_DE Revision C February 2019
3 Commissioning
3.1 Oil supply
3.1.1 Introduction
In all operating states, a functioning and carefully executed oil supply is an important pre-
requisite for trouble-free operation of the turbocharger.
The lubrication of the turbocharger is usually carried out with oil from the engine oil circula-
tion.
u Comply with the enginebuilder's specifications regarding the selection of lubricating oil
and the oil change intervals.
For more information on the oil supply, refer to Chapter Oil pressure, oil temperature →21.
3.1.2 Pre-lubrication and post-lubrication
The pre-lubrication time is at least 2 minutes.
The post-lubrication time is 10 minutes.
If the engine is operated in idle mode 10 minutes before stopping, no additional post-lubric-
ation is required.
3.1.3 Oil filtering
Filtering of the lubricating oil with a filter mesh width of ≤0.050mm is sufficient for the tur-
bocharger.
3.1.4 Oil pressure
Comply precisely with the oil pressure before the turbocharger for trouble-free operation.
Page 18 / 108
To Next Page
Loading...
Need help?
General
