ACQ550-U1 User’s Manual 11
Installation
Installation
Study these installation instructions carefully before proceeding. Failure to observe
the warnings and instructions may cause a malfunction or personal hazard.
WARNING! Before you begin read chapter Safety on page 5.
Note: The installation must always be designed and made according to applicable
local laws and regulations. ABB does not assume any liability whatsoever for any
installation which breaches the local laws and/or other regulations. Furthermore, if
the recommendations given by ABB are not followed, the drive may experience
problems that the warranty does not cover.
Installation flow chart
The installation of the ACQ550 adjustable speed AC drive follows the outline below.
The steps must be carried out in the order shown. At the right of each step are
references to the detailed information needed for the correct installation of the drive.
Task See
PREPARE for installation Preparing for installation on page 12
PREPARE the mounting location Prepare the mounting location on page 16
REMOVE the front cover Remove the front cover on page 17
MOUNT the drive Mount the drive on page 18
INSTALL wiring Wiring overview on page 19 and
Install the wiring on page 26
CHECK installation Check installation on page 31
REINSTALL the cover Reinstall the cover on page 32
START-UP How to start up the drive on page 33
To Next Page
Loading...
