ABB ACQ550-x1-06A6-2 - Page 133

ACQ550-U1 User’s Manual 133
Parameters
3405 OUTPUT1 UNIT
Selects the units used with the first display parameter.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM = 9 (DIRECT).
3406 OUTPUT1 MIN
Sets the minimum value displayed for the first display parameter.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM = 9 (DIRECT).
3407 OUTPUT1 MAX
Sets the maximum value displayed for the first display parameter.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM = 9 (DIRECT).
3408 SIGNAL2 PARAM
Selects the second parameter (by number) displayed on the control panel. See parameter 3401.
3409 SIGNAL2 MIN
Defines the minimum expected value for the second display parameter. See parameter 3402.
3410 SIGNAL2 MAX
Defines the maximum expected value for the second display parameter. See parameter 3403.
3411 OUTPUT2 DSP FORM
Defines the decimal point location for the second display parameter. See parameter 3404.
3412 OUTPUT2 UNIT
Selects the units used with the second display parameter. See parameter 3405.
3413 OUTPUT2 MIN
Sets the minimum value displayed for the second display parameter. See parameter 3406.
3414 OUTPUT2 MAX
Sets the maximum value displayed for the second display parameter. See parameter 3407.
3415 SIGNAL3 PARAM
Selects the third parameter (by number) displayed on the control panel. See parameter 3401.
3416 SIGNAL3 MIN
Defines the minimum expected value for the third display parameter. See parameter 3402.
3417 SIGNAL3 MAX
Defines the maximum expected value for the third display parameter. See parameter 3403.
3418 OUTPUT3 DSP FORM
Defines the decimal point location for the third display parameter. See parameter 3404.
3419 OUTPUT3 UNIT
Selects the units used with the third display parameter. See parameter 3405.
3420 OUTPUT3 MIN
Sets the minimum value displayed for the third display parameter. See parameter 3406.
Code Description
0 = NO UNIT 9 = °C 18 = MWh 27 = ft 36 = l/s 45 = Pa 54 = lb/m 63 = Mrev
1 = A 10 = lb ft 19 = m/s 28 = MGD 37 = l/min 46 = GPS 55 = lb/h 64 = d
2 = V 11 = mA 20 = m
3
/h 29 = inHg 38 = l/h 47 = gal/s 56 = FPS 65 = inWC
3 = Hz 12 = mV 21 = dm
3
/s 30 = FPM 39 = m
3
/s 48 = gal/m 57 = ft/s 66 = m/min
4 = % 13 = kW 22 = bar 31 = kb/s 40 = m
3
/m 49 = gal/h 58 = inH
2
O67 = Nm
5 = s 14 = W 23 = kPa 32 = kHz 41 = kg/s 50 = ft
3
/s 59 = in wg 68 = Km
3
/h
6 = h 15 = kWh 24 = GPM 33 = ohm 42 = kg/m 51 = ft
3
/m 60 = ft wg
7 = rpm 16 = °F 25 = PSI 34 = ppm 43 = kg/h 52 = ft
3
/h 61 = lbsi
8 = kh 17 = hp 26 = CFM 35 = pps 44 = mbar 53 = lb/s 62 = ms
The following units are useful for the bar display.
117 = %ref 119 = %dev 121 = % SP 123 = Iout 125 = Fout 127 = Vdc
118 = %act 120 = % LD 122 = %FBK 124 = Vout 126 = Tout