ABB ACQ80-04 - Fault and Warning Messages; Drive and Panel Communication Failure; Status Light

Start up and use 27
EN
ES
PL
TR
ZH
Fault and warning messages
For more information on fault and warning messages, see the drive firmware manual.
Drive and panel communication failure
Status light
Fault messages
The display shows the active fault message when a problem is
detected.
When a fault message code is displayed:
1. Identify and eliminate the cause. See list of Fault messages on
page 63.
2. Press Reset in the Fault view.
Warning messages
The display shows warning message codes when a problem is
detected.
To view the warning messages list:
1. Open the Main menu .
2. Select Diagnostics and open the Warning messages list.
See list of Warning messages on page 57.
The drive does not respond to the panel commands during
communication failure.
The drive and the panel are not compatible.
Continuous green Indicates that drive is functioning normally.
Green, blinking Indicates an active warning in the drive.
Red, continuous Indicates an active fault in the drive.
Loc 46.0Hz
1001
Reset?
Loc 46.0Hz
Warning:2009
Warning:2020
Warning:2009
ACQ80R0-R8 QIG.book Page 27 Friday, February 1, 2019 1:18 PM