ABB ACQ80-04 - Page 49

Parameters List 49
EN
TR
ZH
96.04 Macro select 0, 1, 14 - Done[0]
96.05 Macro active See parameter 96.04 Macro
select
-
ABB
standard[1]
96.06 Parameter restore 0, 2, 8, 32, 62, 512, 1024,
34560
- Done[0]
96.07 Parameter save manually Done[0], Save[1] - Done[0]
96.08 Control board boot No action[0], Reboot[1] - No action[0]
96.10 User set status 0...11 - n/a[0]
96.11 User set save/load 0...5, 18...21 - No action[0]
96.12 User set I/O mode in1
0...7, 18...20, 24...26 -
Not
selected[0]
96.13 User set I/O mode in2 See parameter 96.12 User set
I/O mode in1
-
Not
selected[0]
96.16 Unit selection 0b0000…0b1111 - 0b0000
96.20 Time sync primary source 0, 3, 6, 8, 9 - Panel link[8]
96.51 Clear fault and event logger Done[0], Reset[1] - Done[0]
96.100 Change user pass code 10000000…99999999 - -
Index Name Range/List Unit Default
Bit Name Bit Name
0 End user 10 Override lock
1 Service 11 OEM access level 1
2 Advanced programmer 12 OEM access level 2
3 Reserved 13 OEM access level 3
4 Long menu 14 Parameter lock
5...9 Reserved 15 Reserved
Done[0] ABB standard[1] PID[14]
Done[0] Reset all fieldbus settings[32] Reset end user texts[1024]
Reset motor data[2] Clear all[62] All to factory defaults[34560]
Restore defaults[8] Reset home view[512]
n/a[0] Faulted[3] User3 IO active[6] User2 backup[9]
Loading[1] User1 IO active[4] User4 IO active[7] User3 backup[10]
Saving[2] User2 IO active[5] User1 backup[8] User4 backup[11]
No action[0] Load set 2[3] Save to set 1[18] Save to set 4[21]
User set I/O mode[1] Load set 3[4] Save to set 2[19]
Load set 1[2] Load set 4[5] Save to set 3[20]
Not selected[0] DI2[3] DI5[6]
Timed function 2[19] -
Not applicable
Supervision 2[25]
Selected[1] DI3[4] DI6[7]
Timed function 3[20] -
Not applicable
Supervision 3[26]
DI1[2] DI4[5]
Timed function [18] -
Not applicable
Supervision 1[24] Other...
Bit Name Bit Name Bit Name
0 Power unit 1 Reserved 2 Temperature unit
3 Reserved 4 Torque unit 5…15 Reserved
Internal[0] Fieldbus A[3] Embedded FB[6] Panel link[8] Ethernet tool link[9]
ACQ80R0-R8 QIG.book Page 49 Friday, February 1, 2019 1:18 PM