• The integral solid state short circuit protection of the drive does not provide branch
circuit protection.
• The drive provides motor overload protection. For adjustments, see the firmware
manual.
• The drive overvoltage category according to IEC 60664-1 is III
Disclaimers
￭ Generic disclaimer
The manufacturer shall have no obligation with respect to any product which (i) has
been improperly repaired or altered; (ii) has been subjected to misuse, negligence or
accident; (iii) has been used in a manner contrary to the manufacturer’s instructions; or
(iv) has failed as a result of ordinary wear and tear.
￭ Cybersecurity disclaimer
This product can be connected to and to communicate information and data via a network
interface. The HTTP protocol, which is used between the commissioning tool (Drive
Composer) and the product, is an unsecured protocol. For independent and continuous
operation of product such connection via network to commissioning tool is not necessary.
However it is Customer's sole responsibility to provide and continuously ensure a secure
connection between the product and Customer network or any other network (as the
case may be). Customer shall establish and maintain any appropriate measures (such
as but not limited to the installation of firewalls, prevention of physical access, application
of authentication measures, encryption of data, installation of anti-virus programs, etc)
to protect the product, the network, its system and the interface against any kind of
security breaches, unauthorized access, interference, intrusion, leakage and/or theft of
data or information.
Notwithstanding any other provision to the contrary and regardless whether the contract
is terminated or not, ABB and its affiliates are under no circumstances liable for damages
and/or losses related to such security breaches, any unauthorized access, interference,
intrusion, leakage and/or theft of data or information.
164 Technical data
To Next Page
Loading...
