Unpacking the delivery
Keep the drive in its package until you are ready to install it. After unpacking, protect
the drive from dust, debris and moisture.
Make sure that these items are included:
• drive
• options, if ordered with an option code
• BMIO-01 I/O module (in standard variant) or other extension module (in configured
variant)
• mounting template (drives with frame size R3 or R4 only)
• installation accessories (cable clamps, cable ties, hardware)
• multilingual warning sticker sheet (residual voltage warning)
• safety instructions
• quick installation and start-up guide
• user interface guide (behind the drive front cover)
• hardware and firmware manuals, if ordered with an option code.
Make sure that there are no signs of damage to the items.
Installing the drive
￭ To install the drive with screws
1. Make marks onto the surface for the mounting holes. Use the included mounting
template for frames R3 and R4. For other frames, see the dimension drawings.
2. Drill the holes for the mounting screws.
3. If necessary, install anchors or plugs into the holes.
4. Install the mounting screws into the holes. Leave a gap between the screw head
and installation surface.
Mechanical installation 45
To Next Page
Loading...
