￭ Connection procedure
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation or maintenance work.
Refer to Terminal data for the power cables (page 147) for the tightening torques.
1.
Do the steps in section Electrical safety precautions (page 17) before you start the
work.
2. Install the conduits, and attach them to the cable entry plate of the enclosure that
the drive is installed in.
3. Make sure that the conduit is correctly grounded at the cable entry.
4. Strip the conductor ends and pull the conductors through the conduits.
5. Remove the screw on the drive front cover, then remove the front cover.
6. Attach the residual voltage warning sticker in the local language to the drive.
7. Connect the protective earth (ground) conductor of the motor wiring to the grounding
terminal.
Electrical installation – North America 97
To Next Page
