ABB ACS380 - Terms and Abbreviations

Terms and abbreviations
DescriptionTerm
Industrial assistant non-Bluetooth control panelACS-AP-I
Standard assistant control panelACS-AP-S
Industrial assistant control panel with Bluetooth interfaceACS-AP-W
Basic control panelACS-BP-S
Optional auxiliary power extension moduleBAPO
Optional CANopen adapter moduleBCAN
Optional USB to RJ45 cableBCBL-01
Optional I/O extension module. Can be installed to the drive together with
a fieldbus adapter module.
BIO-01
I/O & Modbus extension moduleBMIO-01
Conducts the surplus energy from the intermediate circuit of the drive to
the brake resistor when necessary. The chopper operates when the DC
link voltage exceeds a certain maximum limit. The voltage rise is typically
caused by deceleration (braking) of a high inertia motor.
Brake chopper
Dissipates the drive surplus braking energy conducted by the brake chopper
to heat
Brake resistor
Optional relay output extension moduleBREL
Optional encoder interface moduleBTAC
The capacitors connected to the DC linkCapacitor bank
Configuration adapterCCA-01
The part in which the control program runs.Control unit
DC circuit between rectifier and inverterDC link
Energy storage which stabilizes the intermediate circuit DC voltageDC link capacitors
Frequency converter for controlling AC motorsDrive
Embedded fieldbusEFB
Electromagnetic compatibilityEMC
Fieldbus adapterFBA
Optional CANopen® adapter moduleFCAN
Optional ControlNet™ adapter moduleFCNA-01
Optional DeviceNet™ adapter moduleFDNA-01
Optional EtherCAT® adapter moduleFECA-01
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and
PROFINET IO® protocols, 2-port
FENA-21
Optional Ethernet POWERLINK adapter moduleFEPL-02
Optional PROFIBUS DP® adapter moduleFPBA-01
Physical size of the drive or power moduleFrame, frame size
Insulated gate bipolar transistorIGBT
DC circuit between rectifier and inverterIntermediate circuit
Converts direct current and voltage to alternating current and voltage.Inverter
Introduction to the manual 25