ABB ACS380 - STO Function Use, Maintenance, and Fault Tracing

Use
1. Open the activation switch, or activate the safety functionality that is wired to the
STO connection.
2. The STO inputs on the drive control unit de-energize, and the control unit cuts off
the control voltage from the output IGBTs.
3.
The control program generates an indication as defined by parameter 31.22 (see
the firmware manual of the drive).
4. The motor coasts to a stop (if running). The drive will not restart while the activation
switch or safety relay contacts are open.
5. Deactivate the STO by closing the activation switch, or resetting the safety
functionality that is wired to the STO connection.
6. Reset any faults before restarting.
WARNING!
The Safe torque off function does not disconnect the voltage of the main and
auxiliary circuits from the drive. Therefore maintenance work on electrical parts
of the drive or the motor can only be carried out after isolating the drive from the
supply and all other voltage sources.
WARNING!
The drive cannot detect or memorize any changes in the STO circuitry when the
drive control unit is not powered. If both STO circuits are closed and a level-type
start signal is active when the power is restored, it is possible that the drive starts
without a fresh start command. Take this into account in the risk assessment of
the system.
This is also valid when the drive is only powered by a BAPO-xx auxiliary power
extension module.
WARNING!
(With permanent magnet or synchronous reluctance [SynRM] motors only)
In case of a multiple IGBT power semiconductor failure, the drive can produce an
alignment torque which maximally rotates the motor shaft by 180/p degrees (with
permanent magnet motors) or 180/2p degrees (with synchronous reluctance
[SynRM] motors) regardless of the activation of the Safe torque off function. p
denotes the number of pole pairs.
Notes:
• If a running drive is stopped by using the Safe torque off function, the drive will cut
off the motor supply voltage and the motor will coast to a stop. If this causes danger
The Safe torque off function 195