ABB ACS380 - Control Cable Connection Procedures

13. Connect the other ends of the conductors.
Connecting the control cables
Before you connect the control cables, make sure that all option modules are installed.
￭ Default I/O connection diagram (ABB standard macro)
This connection diagram is valid for drives with the BMIO-01 I/O & Modbus extension
module:
• Standard variant (ACS380-04xS)
• Configured variant (ACS380-04xC) with the BMIO-01 I/O & Modbus extension module
(option +L538)
Electrical installation – North America 99