ABB ACS380 - Home View; Status Icons

•
Push the OK key to open the highlighted setting or item.
• Use the left and right arrow keys to highlight a value.
• Use the up and down keys to set a value.
•
Push the Back key to cancel a setting or return to the previous view.
￭ Home view
The Home view shows the reading of one of three measured signals. Select the page
with the left and right arrow keys.
The status bar at the top of the Home view shows:
•
The control location (Loc for local control and Rem for remote control)
• The status icons
• The reference target value
From the Home view, push the Back key to open the Options view and push the OK
key to open the Menu.
Adjust the current reference value with the up and down arrow keys.
Status icons
DescriptionAnimationIcon
Local Start/Stop enabledNone
StoppedNone
Stopped, start inhibitedNone
Stopped, start commanded but inhibitedBlinks
Running at referenceRotates
Running but not at referenceRotates
Running at reference, but reference = 0Blinks
Drive faultBlinks
Local reference setting enabledNone
Operation principle and hardware description 41