6
Electrical installation – IEC
Contents of this chapter
This chapter describes how to:
• measure the insulation
• do the grounding system compatibility check
• change the EMC filter or ground-to-phase varistor connection
• connect the power and control cables
• install optional modules
• connect a PC.
Warnings
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation or maintenance work.
Required tools
To do the electrical installation, you need the following tools:
• wire stripper
• screwdriver or wrench with a set of suitable bits. For motor cable terminals, the
recommended screwdriver shaft length is 150 mm (5.9 in).
Electrical installation – IEC 65
To Next Page
