ABB ACS880 PCP - Page 118

118 Parameters
06.17 Drive status word 2 Drive status word 2.
This parameter is read-only.
-
0000h…FFFFh Drive status word 2. 1 = 1
No. Name/Value Description Def/
FbEq16
Bit Name Description
0 Identification run
done
1 = Motor identification (ID) run has been performed
1 Magnetized 1 = The motor has been magnetized
2 Torque control 1 = Torque control mode active
3 Speed control 1 = Speed control mode active
4 Power control 1 = Power control mode active
5 Safe reference
active
1 = A “safe” reference is being applied by functions such
as parameters 49.05 and 50.02
6 Last speed active 1 = A “last speed” reference is being applied by functions
such as parameters 49.05 and 50.02
7 Loss of reference 1 = Reference signal lost
8 Emergency stop
failed
1 = Emergency stop failed (see parameters 31.32 and
31.33)
9 Jogging active 1 = Jogging enable signal is on
10 Above limit 1 = Actual speed, frequency or torque equals or exceeds
limit (defined by parameters 46.31…46.33). Valid in both
directions of rotation.
11 Emergency stop
active
1 = An emergency stop command signal is active, or the
drive is stopping after receiving an emergency stop
command.
12 Reduced run 1 = Reduced run active (see section See parameter group
47 Data storage (page 281). on page 92)
13 Reserved
14 Stop failed 1 = Stopping failed (see parameter 31.37 and 31.38.
15 Reserved