ABB CBXi Series - Page 40

CBXi IP Controller | Installation
©ABB 2022 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
40
MAN0141 rev 2
3
Note: The MS/TP baud rate must match on all devices on the MS/TP subnet. For the CBXi this is set in the
RS485 Port > Configuration page:
Note: A CBXi cannot have both BACnet MS/TP trunk and a Modbus RTU trunk simultaneously, but a CBXi
controller that has an MS/TP subnet can read and write points to Modbus devices over IP.