ABB CBXi Series - Page 44

CBXi IP Controller | Installation
©ABB 2022 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
44
MAN0141 rev 2
3
Attaching RMC terminals
Remove the Interconnect (if installed) from the right-hand side of the FLX, FBXi, CBXi or CBX where the
RMC is to be installed.
Slide one RMC connector into the T-slot of the CBX or FLX at the point at which the BUS is to be
extended.
Replace the Interconnect