4 Repair
4.6.2. Replacement of motor, axis 2
1533HAC023637-001 Revision: B
15. Refit the cover, frame. Replace the gasket, if
damaged.
Shown in the figure Location of
motor axis 2 on page 150.
Art. no. for the gasket is specified in
section Required equipment on
page 150.
16. Perform a leak-down test. Detailed in section Performing a
leak-down test on page 100.
17. Refill the gearbox with oil. Type of oil and amount is specified
in section Oil in gearboxes on page
91.
18. Recalibrate the robot! Calibration is detailed in a separate
calibration manual, enclosed with
the calibration tools.
General calibration information is
included in section Calibration
information on page 175.
19.
DANGER!
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in section DANGER - First test run may
cause injury or damage! on page 32.
Action Note
Continued
To Next Page
Loading...
