ABB IRB 1600 - 5/1.2 - Restricting the Working Range; Introduction

2 Installation and commissioning
2.4.1. Introduction
3HAC023637-001 Revision: B66
2.4 Restricting the working range
2.4.1. Introduction
General
When installing the robot, make sure that it can move freely within its entire working space.
If there is a risk that it may collide with other objects, its working space should be limited.
The working range of the following axes may be restricted:
• Axis 1, hardware (mechanical stop and position switch)
• Axis 2, hardware (mechanical stop)
• Axis 3, hardware (mechanical stop)
This section describes how to install hardware that restricts the working range.
Notice that adjustments must also be made in the software. References to software manuals
are given in the following installation procedures.