6 Reference information
6.7. Special tools
1933HAC 026048-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
Dismounting tool, tilthouse shaft
The tool for removing the tilthouse shaft from the tilthouse is assembled with the parts shown
in the figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are only given for identification.
xx0600002589
B Mounting tool, tilthouse shaft. Assembly is shown in the figure Mounting tool,
tilthouse shaft on page 194.
C Mounting tool, bearing race and sealing, upper arm. Assembly is shown in the
figure Mounting tool, bearing race and sealing, upper arm on page 195.
D Dismounting tool, bearing race, upper arm. Assembly is shown in the figure
Dismounting tool, bearing race, upper arm on page 195.
E Press tool, link. Assembly is shown in the figure Press tool, link on page 198.
F Press sleeve, art. no. specified in the table Special tools on page 191.
A Hydraulic cylinder, 3HAC11731-1
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
F Sleeve, 3HAC023963-027
G Nut, 3HAC023963-028
J Pad, 3HAC023963-029
Continued
Continues on next page
To Next Page
Loading...
