6 Reference information
6.7. Special tools
1973HAC 026048-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
Mounting tool, bearing race, tilthouse shaft
The tool for fitting a bearing race to the tilthouse shaft is assembled with the parts shown in
the figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are given only for identification.
xx0600002658
A Hydraulic cylinder, 3HAC11731-1
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
G Nut, 3HAC023963-028
H Sleeve, 3HAC023963-037
Continued
Continues on next page
To Next Page
Loading...
