Navigator 500
Sodium analyzer 5 Calibration
OI/ASO550–EN Rev. G 27
14. Press the key (below the Continue prompt).
The next Process Calibration page displayed shows an
average of the reading obtained:
A new value can be added at this page.
15. Use the / keys to move the cursor to the numeral
to be edited in the New 000.00 reading on the screen.
To enter the value, press the key (below the Next
prompt).
Once the new value has been entered, press the key
(below the Continue prompt).
The process calibration offset is calculated and a page
with a moving time bard is displayed for the duration of the
calculation:
When the calculation is finished, a new page showing the
new reading and process calibration offset values is
displayed
The Process Calibration (PC) Offset is displayed in the
transmitter’s Signals View – see Section 6.6, page 33.
It is toggled with the Concentration Value. The Process
Calibration (PC) Offset is also displayed in the transmitter’s
Calibration Log.
16. Press the key (below the Exit prompt) to return to the
Sensor Calibration page
17. Press the key (below the Back prompt).
The Calibrate page is displayed:
18. Press the key (below the Exit prompt) to exit the
configuration level menu.
Note. If the new concentration value is not entered
into the transmitter within 5 hours of the sample
collection the process calibration procedure is
aborted automatically.
New 000.00
AVG 2.93 ppb
Process Calibration
Next Continue
3
New 00 .00
AVG 2.93 ppb
Process Calibration
Next Continue
AVG 2.93 ppb
Process Calibration
Abort
Note. The PC Offset can be removed from the
concentration calculation by carrying out a single- or
two-point calibration.
Exit
New 3.00 ppb
PC Offset 0.007
Process Calibration
Sensor Calibration
Process Calibration
Back Select
To Next Page
Loading...
