ABB PST210 - Page 113

Settings and configuration
Chapter 7
113
1SFC132003M0201
Second sequence parameters (2nd Seq .Param.)
To set parameters related to the second sequence, enter the
2nd Seq. Param. group.
Following parameters can be adjusted:
2nd Set Ie Setting current.
Start Ramp2 Ramp time for start.
Init Volt2 Initial voltage.
Curr Lim2 Current limit.
Press Store to save the selected parameter.
Third sequence parameters (3rd Seq .Param.)
To set parameters related to the third sequence, enter the 3rd
Seq. Param. group.
Following parameters can be adjusted:
3rd Set Ie Setting current.
Start Ramp3 Ramp time for start.
Init Volt3 Initial voltage.
Curr Lim3 Current limit.
Press Store to save the selected parameter.
For wiring and operation of the start/stop signals, see
Chapter 5 “Connection” under programmable inputs.