ABB PST210 - Page 128

Function
128
1SFC132003M0201
External by-pass ............................................................................................. 151
High current warning ....................................................................................... 152
High current warning level............................................................................... 152
Low current warning........................................................................................ 152
Low current warning level ............................................................................... 153
Overload warning ............................................................................................ 153
Overload warning level.................................................................................... 153
Thyristor (SCR) overload warning................................................................... 154
Phase loss fault, type of operation .................................................................. 154
Fieldbus fault, type of operation ...................................................................... 154
Frequency fault, type of operation................................................................... 155
Heat sink over-temperature fault, type of operation ........................................ 155
Thyristor short circuit fault, type of operation .................................................. 156
By-pass doesn't open fault,
type of operation ............................................................................................. 156
By-pass doesn't close fault,
type of operation ............................................................................................. 157
Programmable inputs, In0 and In1 .................................................................. 157
Programmable output relays, K4, K5 and K6.................................................. 159
Programmable software output V7.................................................................. 161
Analog output .................................................................................................. 161
Analog output, reference................................................................................. 162
Analog output, type of value............................................................................ 162
Analog output, range max ............................................................................... 163
Fieldbus control............................................................................................... 164
Fieldbus type................................................................................................... 165
Fieldbus address............................................................................................. 166
Fieldbus auto disable ...................................................................................... 166
Sequence start, number of sequences ........................................................... 167
Start ramp, first sequence ............................................................................... 167
Initial voltage, first sequence........................................................................... 168
Current limit, first sequence ............................................................................ 168
Setting current, first sequence ........................................................................ 168
Start ramp, second sequence ......................................................................... 169
Initial voltage, second sequence ..................................................................... 169
Current limit, second sequence....................................................................... 169
Setting current, second sequence................................................................... 170
Start ramp, third sequence.............................................................................. 170
Initial voltage, third sequence.......................................................................... 170
Current limit, third sequence ........................................................................... 171
Setting current, third sequence ....................................................................... 171
Language ........................................................................................................ 172