Settings and configuration
Chapter 7
79
1SFC132003M0201
Low current warning X X
Low current warning level X X
Overload warning X X
Overload warning level X X
Thyristor (SCR) overload warning X X
Phase loss fault, type of operation X X
Fieldbus fault, type of operation X X
Frequency fault, type of operation X X
Heat sink over-temperature fault,
type of operation
XX
Thyristor short circuit fault, type of
operation
XX
By-pass doesn't open fault, type
of operation
XX
By-pass doesn't close fault, type
of operation
XX
Programmable input In0 X X
Programmable input In1 X X
Programmable output relay K4 X X
Programmable output relay K5 X X
Programmable output relay K6 X X
Programmable software output V7 X X
Event for relay K4 X X
Event for relay K5 X X
Event for relay K6 X X
Event for software output V7 X X
Analog output X X
Analog output, reference X X
Analog output, type of value X X
Analog output, range max X X
Fieldbus control X X
Fieldbus type X X
Fieldbus address X X
Fieldbus auto disable
XX
Sequence start, number of
sequences
XX
Start ramp, first sequence X X
Initial voltage, first sequence X X
Current limit, first sequence X X
Setting current, first sequence X X
Start ramp, second sequence X X
Initial voltage, second sequence X X
Current limit, second sequence X X
Setting current, second sequence X X
Start ramp, third sequence X X
Initial voltage, third sequence X X
Current limit, third sequence X X
Setting current, third sequence X X
Language XX
LCD automatic switch-off X X
Date type XX
Year XX
Month XX
Day XX
Hour XX
Minutes XX
Setting/parameter Top
level
Application
Setting
Basic
Settings
Functional
Settings
Presentation
Settings
All
Settings
Reset all
Settings
To Next Page
Loading...
