ABB Network Partner AB
I/O system configuration
Version 1.0-00
1MRK 580 190-XEN
Page 4 - 22
5Testing
I/O modules that are not configured are not supervised. When an I/O mod-
ule is configured as a logical I/O module (BIM, BOM, IOM, or MIM), the
logical I/O modules
are supervised.
Each logical I/O module has an error flag that is set if anything is wrong
with any signal or the whole module. The error flag is also set when there
is no physical I/O module of the right type present in the connected slot.
You can find status for inputs and outputs as well as self supervision sta-
tus from built-in MMI menus:
Terminal Status
Self Superv
..., Slotxx-BIMyy=, ...
OK/FAILED
Service Report
Slotxx-BIMyy
IOzz-BI1=, ..., IOzz-Error=
0/1 0/1
To Next Page
Loading...
