ABB REC 561 - Setting Internal Time; Additional Information

Local man machine
communication
ABB Network Partner AB
1MRK 580 156-XEN
Page 3 - 33
Version 1.0-00
The window in Fig. 14c reappears, and then you can configure another
signal for the same function.
6.7 Setting internal time Use the setting menu to set the internal time for a complete terminal,
according to Fig. 15.
.
Fig. 15 Setting internal time within a terminal
After you select the E button, the data window changes from Fig. 15a to
Fig. 15b. Note that the cursor is always positioned under the seconds
value when you begin. Select the left arrow to move to the date value.
Real time in a terminal uses these values:
• YYYY, year
• MMM, first three letters of the month’s name
• DD, day in the month
• hh, hour
• mm, minutes
• ss, seconds
Apply the rules for setting a string when you set the month value. All
other values are real values.
6.8 Additional information The terminal also provides more information about its operation, configu-
ration, and service conditions. The following information is available
(also depending on the basic functions and options included in a particular
terminal):
• Phasors of primary and secondary voltages and currents and other
measured values.
• Logical signals that are active during the communication procedure.
• Summary of the recorded disturbance under observation.
• Time of the disturbance under observation.
• The version of software that is built into the terminal.
• The version of hardware that is built into the terminal.
.Set/Time
Date & Time=
YYYY-MMM-DD
a)
YYYY-MMM-DD
b)
E
.Set/Time
Date & Time=
(X80156-15)
hh:mm:ss
hh:mm:ss