ABB REF615 - Page 11

IED settings for IED functionality.................................................65
IED settings for different operating conditions.............................66
Section 6 Operating procedures.....................................................67
Monitoring.........................................................................................67
Indications...................................................................................67
Monitoring indication messages.............................................67
Monitoring an internal IED fault .............................................68
Monitoring condition monitoring data.....................................68
Measured and calculated values.................................................68
Measured values....................................................................68
Using LHMI for monitoring......................................................69
Recorded data.............................................................................69
Creating disturbance recordings............................................70
Monitoring disturbance recorder data.....................................70
Controlling and uploading disturbance recorder data.............71
Monitoring fault records..........................................................71
Monitoring events...................................................................72
Remote monitoring......................................................................72
Operating IED remotely..........................................................72
Controlling........................................................................................73
Controlling circuit breakers and disconnectors............................73
Resetting IED...................................................................................74
Clearing and acknowledging via LHMI........................................74
Changing IED functionality...............................................................75
Defining setting group..................................................................75
Activating a setting group.......................................................75
Copying a setting group.........................................................76
Selecting a setting group for editing.......................................76
Browsing and editing setting group values.............................77
Activating LEDs...........................................................................79
Section 7 Troubleshooting .............................................................81
Fault tracing......................................................................................81
Identifying hardware errors..........................................................81
Identifying runtime errors.............................................................81
Identifying communication errors.................................................81
Checking the communication link operation...........................81
Checking the time synchronization.........................................82
Running the display test..............................................................82
Indication messages.........................................................................82
Internal faults...............................................................................82
Warnings.....................................................................................84
LED and display messages.........................................................86
Table of contents
615 series 3
Operation Manual