ABB RMC-100 - Page 140

140 | RMC-100| 2105552MNAE
Figure 7-20: AI 2 default calibration values
10. Click Calibration and select 3 point or 5 point from the drop-down list (Figure 7-21
).
11. Verify that only the Zero Input and Low-Cal Point buttons are enabled and highlighted. The
system enables the buttons in the order required for the calibration.
Figure 7-21: Analog Input 2 tab with default values
12. Click Range. The Analog Input 2 Range dialog displays (Figure 7-22
).